Install this through a 10mm hole in your own brake of clutch fluid reservoir cap to
switch on a warning light when your fluid level drops below the lowest float level.
Internal switch contacts make when float is at it's lowest position.
(NOTE: Don't forget to redrill the breather hole in the cap if it had one.)
Resistant to all brake and clutch fluids but OK for water too.
28mm float travel. Rubber seal. 300mm fly leads.
Float diameter 26mm.
54mm required depth from inside of cap.
Overall height 70mm.
SWITCH ONLY - CAP NOT INCLUDED.
BRAKE FLUID FLOAT SWITCH #FLSW2