Pedal Box Black

PEDAL BOX - HYDRAULIC CLUTCH WITH INTEGRAL THROTTLE PEDAL Here's a black powder-coated floor-mounted pedal box. Nicely made from 2.7mm and 5mm steel. The clutch pedal has a 6 to 1 ratio and the brake pedal has 4.75 to 1. Both brake and clutch pedals pivot on nylon bushes. The bottom half of the throttle pedal (below the pivot point) has a maximum of 50mm movement. No holes are made for throttle cable or it's connection to the pedal. Three 37mm holes for master cylinders. All of our standard, Integral Reservoir and Non-Reservoir cylinders will fit although the push rods may require shortening. The 26mm I.D. balance bar tube is cleverly offset towards one (front brakes) cylinder to 'pre-load' the front to back bias in favour of the front. No floor fixing holes are drilled.

PEDAL BOX #PEDBOX2

NOTE: MASTER CYLINDERS, CLEVIS AND BALANCE BAR ARE NOT INCLUDED. SHOWN ONLY FOR ILLUSTRATION.